The ABB 1MRK002122-AB is a high-reliability interface module designed for the RELion family of protection and control IEDs (Intelligent Electronic Devices). This module serves as a critical communication and signal processing bridge, facilitating the transfer of high-speed data between the relay’s internal logic and external substation secondary equipment. Engineered for the demanding environment of high-voltage substations, it features superior electromagnetic compatibility (EMC) and deterministic signal timing to ensure the safety and stability of power system protection schemes.
Product Technical Specifications
-
Model Number: 1MRK002122-AB
-
Part Number: 1MRK002122-ABR01
-
Module Type: Communication / Interface Module
-
Interface Protocols: IEC 61850-8-1, DNP3, IEC 60870-5-103
-
Voltage Range: 24V – 250V DC (System dependent)
-
Isolation: 2.5 kV AC for 1 minute
-
Operating Temperature: -25°C to +70°C
-
Dimensions: 215mm x 160mm x 25mm
-
Weight: 0.52 kg
-
Country of Origin: Sweden
Application Areas The 1MRK002122-AB is primarily utilized in electrical substation automation systems for distance protection, transformer differential protection, and busbar management. It is a key component in smart grid applications, enabling long-distance communication between protection relays and the Supervisory Control and Data Acquisition (SCADA) system. Its high-speed processing makes it ideal for time-critical functions such as breaker failure protection and line differential signaling.
Product Operating Instructions Installation must be performed by qualified protection and control engineers. Before inserting the 1MRK002122-AB into the relay chassis, ensure the rack power is turned off and standard ESD safety procedures are followed. Align the module with the internal card guides and slide it firmly until the backplane connectors are fully engaged. Secure the module using the front-panel captive screws to establish a consistent ground path. During commissioning, use the PCM600 tool to configure the communication parameters, including IP addresses and GOOSE messaging priorities. Ensure that any fiber optic connections are cleaned with appropriate tools before insertion to prevent signal loss.
Common Questions & Answers
Q: Can this module be used in both 650 and 670 series relays? A: Yes, the 1MRK002122-AB is generally compatible with the modular RELion series, including the 650 and 670 variants, provided the firmware on the IED supports this hardware revision.
Q: Does the module support fiber optic communication directly? A: This board typically serves as the processing interface; physical fiber optic connectivity is usually provided through SFP (Small Form-factor Pluggable) transceivers or specific optical daughter-cards that attach to this module.
Q: What should I check if the communication link is down? A: First, verify the “Link” LED status on the front panel. If dark, check the physical cabling and the configuration settings in PCM600. Ensure the subnet mask and gateway settings match the substation network architecture.
Q: Is this module suitable for harsh outdoor environments? A: While the module has a wide operating temperature range, it must be installed within an IED chassis that is housed in a climate-controlled or protected outdoor cabinet (IP54 or higher) to prevent moisture ingress.
Recommended Similar Models
-
ABB 1MRK002247-AR
-
ABB 1MRK000117-BE
-
ABB 1MRK002133-BA
-
ABB RET670 Transformer Protection Module
-
ABB REC650 Bay Control Module
