Note: All products on this site are special products, the market price has been fluctuating, the specific customer service offer shall prevail, because the product is a new product, the picture is not a real shot, please confirm with customer service before placing an order model and product, price and other details, the site used, new are for sale, please contact customer service communication.
____________________________________________________________________________________________________________________

The PC D232 A module with catalog number 3BHE022293R0101 sits in ABB’s PEC80 range and works as a digital I/O unit and as an excitation controller for generators. It reads up to 32 on/off signals from field devices and drives up to 32 outputs at 24 V. It also sets field voltage and current to keep the generator output steady. The module links to control systems by using common networks like Modbus RTU and TCP, Profibus DP, IEC 60870‑5‑101 and ‑104, DNP3 and OPC. It can also use Ethernet/IP and RS‑485 ports. The module has LEDs for power, run and error states so it is simple to check if it works right. It fits into DCS racks to handle process inputs and outputs or into generator panels to control exciter power. It mounts on a standard DIN‑rail or on a panel with M4 screws. It plugs into mating connectors that lock in place and make swapping it out quick. The module comes ready for use with any PEC80‑based control network or generator control panel.

The module takes power from a supply of 180 V to 264 V AC at line frequency of 47 Hz to 63 Hz. It uses about 12 W in normal use. It works safely from –20 °C to +60 °C and can sit in storage from –40 °C up to +85 °C with up to 95 % relative humidity if there is no condensation. It handles voltage spikes and electrical noise that appear in industrial settings. It has built‑in protection for over‑voltage, under‑voltage, over‑current and reverse power. The protection cuts output drive when it sees a fault. It resets drive automatically when conditions go back in range. The module meets CE rules, has UL approval and carries RoHS marking so it follows EU limits on hazardous substances. It does not need extra filters. It plugs into standard field wiring terminals or into cable assemblies designed for PEC80 frames.

The shape of the module is a block that measures 147 mm wide, 80 mm high and 120 mm deep. It weighs about 0.45 kg. It slides on to a DIN‑rail with a clip that snaps tight. It also can go on a flat panel with screws. It has two RJ45 ports for network use and one RS‑485 port for serial links. It has green and red LEDs on the front for power and status. It has an aluminum heatsink inside to shed heat without a fan. You can get the full English datasheet from ABB’s support website by searching for “3BHE022293R0101 datasheet.” You can also ask any ABB distributor or your local ABB service office to send the PDF by part number.

___________________________________________________________________________________________________________________________________________________________________________

　　For more products, click here

　　This article is from the official website of Xiamen Xiongba, please include the following link for reproduction：
www.fy-module.com | PCD232A101 3BHE022293R0101 digital I/O unit